PELLA
®
INSYNCTIVE
®
INTEGRATED ENTRY DOOR SENSOR PRODUCT GUIDE
|
10
4. Prepare LOCK SENSOR
This lock transmitter is used in multiple INTEGRATED SENSORS
units. The lock transmitter must learn what type of entry door it will
be housed in. Follow the steps below to prep the lock transmitter.
Remove the lock transmitter from the door, and lift up a corner of
the plastic cover to expose the battery.
Remove the plastic tab separating the battery from the device.
Push down on the battery to ensure that the battery is firmly in
place. Make sure plastic cover is flat and in place.
NOTE:
Once the plastic tab is removed from the battery, you
will have 2 minutes for your lock transmitter to learn what type of
door it will be housed in. If 2 minutes pass without the transmitter
successfully learning your door type, follow steps for removing and
reinserting the battery on page 14.
Insert the lock transmitter back into your entry door; close and
lock the door, then wait 10 seconds. The lock transmitter has now
learned what type of door it is housed in.
You are ready to sync LOCK SENSOR to BRIDGE.
5. Sync LOCK SENSOR to BRIDGE
Each INTEGRATED ENTRY DOOR SENSOR will need to be synced
to BRIDGE. You will have 2 minutes after completing Step 4 to
complete this step. If syncing is not successful within 2 minutes,
remove then replace the battery and repeat steps 4 and 5.
DETAILED INSTRUCTIONS
(continued)
LIGHT
SYNC
BUTTON
TEST
BUTTON
BRIDGE
PLASTIC COVER
BATTERY
TAB
BATTERY TAB
REMOVED
UNLOCKED
LOCKED
LOCK
TRANSMITTER
