PELLA
®
INSYNCTIVE
®
INTEGRATED ENTRY DOOR SENSOR PRODUCT GUIDE
|
16
3. Prepare LOCK SENSOR
Use a small flathead screwdriver to remove the battery cover
on LOCK SENSOR. Carefully remove and replace the battery.
Ensure the battery is correctly installed. Replace battery cover
on SENSOR.
NOTE:
Once the battery is removed, you will have 2 minutes to
delete your LOCK SENSOR from BRIDGE. If 2 minutes pass without
successful deletion, remove and insert the battery again.
You are ready to delete INTEGRATED LOCK SENSOR from BRIDGE.
4. Delete LOCK SENSOR
Each INTEGRATED ENTRY DOOR SENSOR will need to be
deleted from BRIDGE.
WITHOUT HOME AUTOMATION (Stand-Alone Mode)
Press and hold BRIDGE Sync button until light begins flashing
orange. The Sync button is the bottom button located on the side
of BRIDGE.
NOTE:
BRIDGE is in sync mode while the orange light is flashing.
BRIDGE will remain in sync mode for 2 minutes. BRIDGE will then
beep, and orange light will turn off to indicate BRIDGE exited
sync mode.
To delete LOCK SENSOR from BRIDGE, ensure your entry door is
closed and locked; then unlock and lock your door 2 times within
10 seconds.
Wait for the light on BRIDGE to flash red and beep 3 times. This
will indicate a successful deletion.
If LOCK SENSOR deletion is unsuccessful, return to Step 3 and
retry the process.
Repeat the previous steps until all INTEGRATED ENTRY DOOR
SENSORS have been deleted from BRIDGE.
To exit sync mode, press and hold Sync button on BRIDGE until
light stops flashing orange.
WITH HOME AUTOMATION
BRIDGE supports two types of home automation systems,
Professionally Installed and Do-It-Yourself (DIY) Z-Wave. Visit
Insynctive.Pella.com
for a list of compatible home automation
systems and deletion instructions.
ADDITIONAL INSTRUCTIONS
(continued)
LIGHT
SYNC
BUTTON
TEST
BUTTON
BRIDGE
LOCK
SENSOR
BATTERY
COVER
BATTERY
BATTERY
COVER
UNLOCKED
LOCKED
