PELA 498192, Руководство пользователя

Страница: 37 / 46

If the machine seems powerless, check that the
drive belt is properly tensioned. To tighten the drive
belt, remove the sheet metal cover on the left side
of the lower part of the machine by unscrewing
the two allen screws (5 mm). Tighten the drive belt
using the adjusting screw located on the motor
stand.
If the locking lever does not lock the vertical arm
properly or if the mounting head cannot be lifted
at least 2 mm above the rim, which is necessary
for proper operation, loosen the nut and adjust the
allen screw according to the figure. To maintain
the reliability of the clincher and clamping jaws,
the mufflers on the valve should be blown clean,
remove the sheet metal cover on the left side of the
machine part by unscrewing the two allen screws
(5 mm). Remove the mufflers from the valve. Clean
with compressed air (purge gun) or replace, if
required.
Problem Cause Measure
The table does not rotate.
The plug is not connected /
there is no power in the mains.
Engine problem.
The foot pedal (Z) does not
work.
The drive belt is poorly
tensioned or broken.
Connect the plug / switch on the
power.
Check and repair the rotary table.
Adjust or replace the drive belt.
The table locks during
assembly / disassembly of
the tire.
Poorly tensioned drive belt.
Tighten the drive belt.
The clamping jaws are open
/ close slowly.
The compressed air muffler is
clogged with dirt.
Clean or replace the compressed
air muffler.
The table does not lock the
rim properly.
Worn clamping jaws.
Defective piston.
Replace the clamping jaws.
Replace the gasket.
The mounting head touches
the rim when mounting /
removing the tire.
The spindle lock is incorrectly
adjusted or defective.
Loosen the screw on the spindle
lock.
Adjust or replace the spindle
lock.
Tighten the screw.
The foot pedal (V) and (U)
are locked in the wrong
position.
The return spring of the pedal is
broken.
Replace the return spring.
Difficult to activate the
clincher.
The compressed air muffler is
clogged.
The valve stem’s O-ring is
broken.
The piston gasket or O-ring is
broken.
Clean or replace the compressed
air muffler.
Replace the O-ring.
Replace the gasket or O-ring.