MODEL:
PDi BELLA-HD Interface
Document Number:
PD196-426R1
User Manual
Page 8 of 27
PDi Communication Systems, Inc. ▪ 40 Greenwood Ln ▪ Springboro, Ohio 45066 USA ▪
www.PDiarm.com
and
www.mymedTV.com
▪ Phone 800.628.9870
Wall Mounted TV - RF Cable Installation
The RF Output Signal cable from each set-top-box (STB) must also be routed to each remotely located television. Please refer to the
STB installation instructions for details.
Arm Mounted Televisions
The PD295-004 interface module is also compatible with several of the PDi Arm Mounted televisions that incorporate a BELLA
interface. Models such as the medTV and medTAB can be used successfully with the interface module when ordered with the BELLA
option.
NOTE: Each TV and its Support Arm must be pre-wired with a CAT6a data cable. Please contact PDi Communication
Systems or your PDi distributor for assistance should your TV and/or Arm lack this cable.
Arm Mounted TV – Data, Power, and IR Emitter Cable Installation
The CAT6a cable used to connect the remotely located TV to the interface module should not exceed 250 feet in length. CAT6a, HDMI
and power cables are not provided with the interface module.
1. Connect one end of the CAT6a cable to the Data Cable from the Arm/TV. The in-room Data Connection is typically wall mounted as
illustrated below.
2. Connect the other end of the CAT6a cable to the RJ45 port on the front of the PD295-004 interface module.
3. If using a DirecTV set top box, connect the USB cable to the PD295-004. No other power supply is needed.
4. Connect the IR Emitter cable to the interface module if used (see note below).
5. Remove adhesive backer from IR Emitter and secure it to the IR receiver window of the STB.
6. For a chassis mounted interface module, connect chassis power cable to PD295-004. For stand-alone mounting, connect power
cord PD106-747 to PD295-004.
