Attaching a bridge interface to a VLAN module
60
Model 6081RC Network Access Server Getting Started Guide
7 • VLAN configuration
3. In the VLAN ID text box, type the desired number for this VLAN (up to 4096 with no reserved VLAN
numbers).
4. Click the
Add VLAN
button.
Configured VLANs are displayed as shown in
figure 38
.
Figure 38. Configured VLAN Interfaces section of VLAN (802.1Q) Configuration page
Attaching a bridge interface to a VLAN module
Once the desired VLAN has been created, it is necessary to attach it to a bridge group as follows:
1. Click the Interface link in the Configuration Menu pane (see
figure 17
on page 37) to display the
Interface page (see
figure 39
).
Figure 39. Interface page
2. Locate the Ethernet port that has the VLAN ID created in section
“Attaching a VLAN ID to an Ethernet
interface”
on page 59 and click to place a checkmark on the box in the Enabled column. Select the desired
bridge group from the menu in Bridge Group column (this bridge group should correspond to the remote
CPE for which a VLAN is required), then click to place a checkmark on the box in the Bridged column.
