![background image](http://html.mh-extra.com/html/patton-electronics/3092/3092_getting-started-manual_763541065.webp)
Maintenance
65
Model 3092 iDSL DACS Getting Started Guide
5 • Troubleshooting and maintenance
19. Press the left-arrow cursor key until the TOP LEVEL MANAGEMENT window displays.
20. Select
a
for Home, then press
<Enter>
.
21. Under the Current Status page, type
1
(storeConfig(1))to save the changes you have just made to the con-
figuration.
22. To import a saved configuration, connect your Web browser to the Administration Pages, then click on
Import/Export
under the
Configuration Menu
to display the
Import/Export
main window (see figure 30 on
page 59).
23. To import a configuration file into the Model 3092, type the complete path and filename for the configu-
ration file you wish to load or click on the
Browse…
button to select the desired file, then click on the
Sub-
mit Query
button (see figure 30 on page 59).
Upon successfully importing the file, the Model 3092 will display Configuration Load Complete, indicating
that the new operating parameters have been loaded into flash memory.
24. Click on
HOME
under the
Configuration Menu
, then click on the
Hard Reset
button under
Immediate
Actions
.
Note
Do not
select
Record Current Configuration
after importing configu-
ration parameters.
Completing the installation
This section verifies that the Model 3092 is fully operational.
1. Temporarily disconnect the male ends of both power cords from the power distribution strip or to a wall
outlet. Wait 30 seconds, then plug the power cords in again.
2. Verify that the green POWER LED is lit. If the POWER LED is flashing green, refer to Chapter 5, “Trou-
bleshooting and maintenance”.
3. Verify that the Link 1 Frame LED illuminates, indicating that the Model 3092 is synchronizing with the
T1/E1 signal.
4. Verify that after 5 seconds, the Link A Error LED begins flashing, indicating that the Model 3092 is satis-
fied with the quality of the T1/E1 signal.
5. Verify that after 10 seconds, the Link A Error LED extinguishes, indicating that the Model 3092 is satisfied
with the network signal and that the link is ready for use.
6. There are two LEDs on the Model 3092 10/100 Ethernet port: a green LED that indicates link status and
activity, and a yellow LED that indicates line speed.
Verify that the green LED is either flashing green (meaning that packets are being received at the Ethernet
port) or solid green (meaning that the link is valid but no packets are being received).
The Model 3092 is operational.
Содержание 3092
