Patton electronics 3092, Руководство по началу работы

Страница: 27 / 74

Cable installation 27
Model 3092 iDSL DACS Getting Started Guide 2 • Hardware installation
Connecting the 10/100Base-T Ethernet port to an Ethernet-capable workstation
The 10/100Base-T Ethernet port can connect to a single Ethernet-capable workstation by means of a cross-
over cable. Refer to figure 10 to assemble a cross-connect cable that will connect between the NIC Ethernet
port in the workstation and the DACS 10/100Base-T Ethernet port.
Figure 10. Cross-over RJ-45-to-RJ-45 Ethernet cable diagram
Connecting the EIA-561 RS-232 configuration port
Install the supplied DB-9-to-RJ-45 cable between the DACS RS-232 port (see figure 8 on page 26) and an
open serial port on your computer. If you need to assemble your own cable, refer to the pinout diagram in
figure 11.
Figure 11.
DB-9-to-RJ-45 cable
diagram
Connecting to the T1/E1 WAN ports
An active T1/E1 is not necessary to configure the DACS. However, an active T1/E1 connection is required to
transfer data from the subscriber’s DSL modem through the WAN port. The factory-set default configuration
of the access server has the T1/E1 ports disabled.
Note The cable connecting the T1/E1 WAN ports to the RJ-48C termina-
tion jack should be CAT-3 or higher and extend no farther than one
mile from the digital services termination.