PS-3225
Assign SmartGate- Smart Gate Only
13
013-16123A
•
The panel shows “Position”, “Velocity”. and
“Acceleration” with “Position” as the default
choice. This measurement gives the amount of
angular distance moved based on the “Spoke
Arc Length” of the Super Pulley. The “Velocity”
measurement gives the angular speed and
direction of the Super Pulley based on the time
between Detector Port 1 and Detector Port 2.
Direction is based on which Detector Port is interrupted first. The “Acceleration” measurement is based on the
“Change in Velocity” per unit of time.
6. Photogate Timing (One Photogate)
•
This option assumes that a flag will be passed through the beam between Emitter Port 1 and Detector Port 1.
1.
Click or touch “Photogate Timing (One Photogate)” to select it and then click or touch “OK” to accept the choice
and close the dialog.
•
The “Edit Timer Properties”
panel is revealed. The “Flag
Length” default value is 0.025 m.
2.
However, if the Length of the flag
you are using to interrupt the
Wireless Smart Gate is a
different length, highlight the
default value in the panel and
enter the flag’s actual value.
3.
Click or touch “OK” to accept the change and close the dialog.
•
The “Select Measurements for Templates” panel
is revealed.The panel shows “Time In Gate” and
“Velocity In Gate” with “Time In Gate” as the
default choice. This measurement gives the
amount of time that the Wireless Smart Gate
beam for Detector Port 1 was blocked. The
“Velocity In Gate” measurement gives the speed
and direction of the flag used to block the beam based on the Flag Length and the Time In Gate.
7. Digital Input
•
This option assumes that a flag will be passed through the beam between Emitter Port 1 and Detector Port 1.
1.
Click or touch “Digital Input” to select it and then click or touch “OK” to accept the choice and close the dialog.
•
The “Select Measurements for Templates” panel
is revealed.
Default Flag Length-
Change if necessary.