Parker TQ10X, Руководство пользователя

Страница: 38 / 139

➁
Installation 29
SEQUENCE SELECT INPUT – The TQ10X can dedicate up to three Sequence
Select inputs that allow you to control seven different sequences. Sequences are
executed remotely by using one of the following logic patterns in conjunction with
the XP command.
Sequence # Ø 1 2 3 4 5 6 7
SEQ Input #1 Ø 1 Ø 1 Ø 1 Ø 1
SEQ Input #2 Ø Ø 1 1 Ø Ø 1 1
SEQ Input #3 Ø Ø Ø Ø 1 1 1 1
Ø = low, pulled to ground
1 = high, 5VDC
STOP or KILL INPUT – The TQ10X can dedicate up to one Stop and one Kill
input. The active state is high. The Stop or Kill input is identical in function to the
effect of the S or K command respectively.
GO INPUT – The TQ10X can dedicate up to one Go input. The active state is
high. The Go input is identical in function to the effect of the GO (G) command.
NOTE
Unless configured otherwise (SSH command), the controller will dump the commands
following the IN command in the buffer. Please pay special attention to the state of the
inputs before entering the IN command.
Output #1 (OUT 1) and Output #2 (OUT 2)
The TQ10X has two dedicated progra5 volt outputs. They may be used to
signal peripheral devices upon the start or completion of a move. The default state
for Outputs #1 and #2 is logic low. Refer to the Output (O) command for informa-
tion on using these outputs.
The next drawing shows the schematic for one of the outputs.
• Maximum low level output: 0.8 V
• Minimum high level output: 2V
ACT04
Internal Connections TQ10X
6 OUT 1
8 GND
Internal Connections for OUT1 and OUT 2 are Identical
Plant
General Purpose Outputs
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com