35
EN
► Loosen the
carriage cover
in the direction of the
end cap drive end
side in order to reach the screws
underneath.
► Place something such as wood underneath the screw.
► Loosen the screws from the
end cap non drive end
side and remove the cover.
► Remove the six screws of the nut slot.
ATTENTION
Risk of damage to runner blocks
Tilting will damage the recirculating ball runner block!
► Carefully move carriage onto the guide rails with a parallel movement.
► Carefully move the carriage from the guide, without tilting, and insert the transport safety device such that
no balls fall out of the runner block.
9.8 Checking the Cover Function
With the IP54 cover, the proper wiper function only occurs when a slight tread can be detected on the Outer band.
Scores or streaks of residue indicate defective or dirty wipers around the carriage. Replacement is required.
9.9 Replacing the Carriage
9.9.1 Disassembly of Carriage Ball Screw Drive
If present, the IP54 cover must be removed (refer to section 7.5.1 on page 17).
Nut slot
End cap non drive end
Carriage cover
End cap drive end
Carriage
Carriage
Runner block
