13
EN
7.2 Installation of Linear Drive
All installation measurements can be found under “6.3 Carrier profile and drive body” on page 8 and in the
HMR catalogue.
► During assembly, the HMR must be sufficiently supported and securely placed in a machine/system.
ATTENTION
Straightness tolerance exceeded
The screw-on surface is important!
► Ensure evenness and straightness.
The maximum straightness and evenness in the running direction of the linear system can only be achieved if the
corresponding mounting points or surfaces are within the required tolerance.
The mounting surface for the profile version must have evenness of at least 0.2 mm/m at the clamping points.
NOTE
► Adhere to the tightening torques for screws
according to section 7.1. on page 12.
7.2.1 Mounting with T-slots
► Use of T-slot profiles. Mounting from below.
Standard screws and sliding blocks or rails from the common profile systems can be used.
Mounting parts such as sliding blocks are available as accessories.
► Please observe the required number of T-sliding blocks in accordance with the axial holding force for
secure assembly (see table below and HMR catalogue page 38).
T-slot mounting
HMRB
T-slot mounting
HMRS
Dimension table
-
T-slot mounting
HMR
Product size
A
B
C
Ø D
M
N
Order no.
HMRx08
8.0
4.0 11.5
M5
5.0
0.5 56351FIL
HMRx11
8.0
4.0 11.5
M5
5.0
0.5 56351FIL
HMRx15
10.5
6.4 22.5
M6
6.4
0.6 56351FIL
HMRx18
13.5
6.7 22.5
M8
8.5
1.0 56352FIL
HMRx24
16.5
8.9 28.5 M10 10.5
1.0 56353FIL
Max, axial holding force per mounting set
Product size
T-slot
mounting
min, number of sets
required per meter
[N]
horizontal horiz,
side
over head vertical
HMRx08
1,000
4
11
19
5
HMRx11
1,000
4
11
19
5
HMRx15
1,600
4
5
10
5
HMRx18
2,700
4
5
10
5
HMRx24
3,200
4
4
8
5