37
EN
End cap non drive end
► Loosen the screw of the
clamping plate
and remove it.
► Pull out the
belt clamping package
.
► Repeat this with the other belt tensioning package.
► This time remove the
belt
of the
belt clamping package
.
► Remove
cover
from the
end cap non drive end
side.
► Lay out the
belt
.
► Loosen the screws from
end cap non drive
end side and remove it.
9.9.3 Disassembly of carriage belt drive
If present, the IP54 cover must be removed as per section 7.5.1 on page 18.
The belt tensioning block needs to be removed on both sides. Following the procedure is described for one side.
Carriage cover
► Loosen the
carriage cover
in order to reach the parts underneath.
► Remove the
lock screw
.
► Loose the nut of the
tension pin
a bit and release the pin.
Tension pin
Nut tension pin
Lock screw
Clamping plate
Belt clamping package
Belt
Cover
End cap non drive end