Paragon P8 Series, Руководство пользователя

Страница: 12 / 32

12 LT6523 ( Iss 4 10/14 )
P8 Users Instructions
SECTION FIVE General Points
Like all appliances incorporating an aerated burner a low
frequency noise may be heard, particularly on the low
setting, this is quite normal and does not affect the
operation of the appliance.
It is advised that a competent person service the P8 fire
annually. The fire is more likely to provide trouble-free
operation.
Dulling and slight discoloration inside the firebox will
occur adding to the realism of the appliance. This is
normal.
It is important that: -
The chimney or flue is checked annually to ensure
clearance of combustion products. This can be
inspected by removing the inner firebox and removal of
the inspection covers located on the back and top of the
outer firebox. This can be obtained by doing the
following.

Remove the two side covers LH and RH which
are held with magnets.

Undo the two M4 and 2 M4 hexagon nuts retaining
the glass fixing bracket using the tool provided
then pull clear and remove from location studs.

Carefully lift the glass panel from within the bottom
retaining slot.

Remove the log fuel bed shapes.

Lift out the air tray assembly from the location
points within the shelf.

Pull out the air grill and disconnect the battery
holder from the lead and remove.

Remove the two screw retaining the gas
connection cover from within the burner shelf and
remove cover. Shut down restrictor elbow and
disconnect the 8mm inlet nut.

Undo the three fixing screws from the burner tray
and lift out burner tray assembly taking care not to
damage the liners.

Carefully bend down the 4 off finger folds located
on the fire box shelf.

Carefully remove the sides top and rear ceramic
liners.

Remove the 4 off fixing screws retaining the inner
inspection plate and remove.

Remove a further 4 off fixing screws retaining the
outer inspection plate and remove.

After inspection for clearance is completed
reassemble in reverse order.