Paragon P8 Series, Руководство пользователя

Страница: 17 / 32

17 LT6523 ( Iss 4 10/14 )
P8 Installation Instructions
SECTION EIGHT Siting the Appliance Continued
CHECKING THE FLUE AND FIRE OPENING

Check that the chimney conforms to the required specifications as previously stated. Examine the
condition and carry out any remedial work including removing any debris from the base.

If the flue has been used for solid fuel it should be swept prior to the installation

Prior to installing the appliance a smoke test (using a smoke bomb) should be carried out to check
that satisfactory smoke clearance has been established.
If all the smoke is not drawn into the flue, pre-heat the flue with a blowtorch or similar and re-
check. If there is any uncertainty examine for the cause and, if necessary, seek expert advice.
No combustible material should be fitted inside the fireplace opening.

When installing this appliance against a dry lined (plasterboard) wall ensure that any void
between the plasterboard and the wall is sealed with a suitable non-combustible material (i.e.
plaster or mortar).
P8 Installation
Instructions
SECTION NINE To Install the
Appliance
GAS SUPPLY ROUTING
Use rigid or semi
– rigid tube to connect the supply.
Determine the gas supply pipe route to the
appliance before installing the fire
. Please note
that if the fireplace frame option is required the
inlet cover retaining screws and nut should be fitted from the rear of the firebox flange at this
stage.
The required fixing can be found within the fireplace frame packaging
Fixing Firebox Assembly

Slide the firebox into the fireplace open guiding the gas
supply pipe through the hole at the rear LH bottom of the
firebox.

Retain the Firebox using wall plugs and screw using the four
holes within the firebox flange.

Refit the grommet over the pipe and seal around the inlet
hole.

Remove the gas connection cover located within the burner
shelf left hand side and connect to the restrictor elbow
provided.
Note: - The isolation valve must be fitted at a angle
to allow access to the restrictor plug plus gas
pressure test nipple.