Paragon P8 Series, Руководство пользователя

Страница: 8 / 32

8 LT6523 ( Iss 4 10/14 )
P8 Users Instructions
SECTIONTHREE Cleaning
Warning: -
Before you clean any part of the appliance ensure that the
appliance is turned off and cold.
CLEANING: PILOT ASSEMBLY (With Fireplace
frame fitted)
(Before cleaning ensure that the appliance is turned off
and cold)
In some instances you may experience ignition problems
even when the appliance is new. This may be due to the
aeration hole in the pilot body being partial blocked with
dust, pet hairs, or other foreign matter. The source of this
debris could be such things as carpet fibres, decorating or
pet etc.
To gain access to the pilot please do the following.

Remove the two side covers LH and RH.

Undo the four M4 nuts retaining the glass fixing
bracket using the tool provided then pull clear
and from the location studs.

Carefully lift the glass panel from within the
bottom location slot.

Remove the log fuel bed shapes and bark
shapes.

Lift out the air tray assembly from the location
points within the shelf.
The pilot is located on the right hand side of the
appliance, any debris in or around the aeration hole
should be remove using the nozzle of a vacuum
cleaner. It is advisable not to blow the debris into the
hole as this may cause more of a restriction and not rectify the problem.
Note: - Take care when cleaning in this area so as not to damage the pilot assembly.
CLEANING: PILOT ASSEMBLY (With
Four sided Trim Fitted)
(Before cleaning ensure that the appliance is
turned off and cold)
In some instances you may experience ignition
problems even when the appliance is new. This
may be due to the aeration hole in the pilot body
being partial blocked with dust, pet hairs, or other
foreign matter. The source of this debris could be
such things as carpet fibres, decorating or pet etc.
To gain access to the pilot please do the
following.

Lift the four sided trim away from the firebox which is held on using four magnets.

Undo the four M4 nuts retaining the glass fixing bracket using the tool provided then pull clear
and from the location studs.