Paragon P8 Series, Руководство пользователя

Страница: 6 / 32

6 LT6523 ( Iss 4 10/14 )
P8 Users Instructions
SECTION TWO Operating the Appliance
Before attempting to operate the appliance check
that nothing has been placed in front of the
appliance that may interfere with the remote sensor
operation.
To light the appliance using the remote hand set:
a. Point the remote control hand set in the direction of
the appliance and simultaneously press the buttons
marked ‘ off’ and ‘standby’. Continue to hold in
these two buttons until a ‘bleep’ is heard
(approximately 2-3 sec.) and then release these
buttons. The appliance will automatically go through
the ignition sequence and the pilot should ignite.
Once the pilot is alight the appliance will
automatically go to the high setting (approximately
20-25sec). If the ignitor stops sparking and the pilot
fails to light, repeat this procedure.
b. The appliance can be adjusted up or down by pressing the
appropriate button
' '
(low setting) or
' '
(high setting).There are 5 heat settings and the fire will
give a double bleep when the maximum or minimum heat setting is reached. To switch off the
appliance press the OFF
' '
button or if the appliance is to be switch off for a short period it is
recommended that the ‘standby’ button be used. This switches the main burner off but leaves the
pilot on and will extend battery life.
c. The appliance can be switched off with out using the hand set by removing the appliance
batteries located behind the ash pan cover. When the batteries are removed there will be a delay
(up to 3minutes) after which double bleeps may be heard and shortly after the appliance will
extinguish. Ensure that the battery is reconnected once the fire as been extinguished. The
appliance cannot be operated without the use of the handset. If the fire fails to light or
extinguishes for any reason, it will be necessary to re-set the fire. This can be done by pressing
the off button then following the normal lighting procedure.
NOTE: If the fire is extinguished for any reason wait 3 minutes before relighting.