Paradox DGP2-641, Справочное и монтажное руководство

Страница: 35 / 44

Digiplex/DigiplexNE LCD Keypad 33 n
enter their PIN on the PosiPIN reader. If section [006] option [4] is
OFF, the user must present their access control card to the reader
and enter their PIN on the keypad.
Option [4] OFF= User enters their PIN on the keypad (default).
Option [4] ON = User enters their PIN on the PosiPIN.
Section [006] option [4] can only be used if connected to a
DigiplexNE (DGP-NE96) control panel. Do not enable
section [006] option [4] if using a normal proximity reader.
6.6.1 C
ONFIGURING
T
HE
P
OSI
PIN’
S
K
EYPAD
In order for the Access Control PIN Entry option (section 6.6
on page 32) to work with the DigiplexNE, the PosiPIN’s keypad
communication format must be set to 8-bit Wiegand. To do so,
from the PosiPIN, perform the following:
Step 1: Press and hold the [
CLEAR
] key for 4 seconds (the
reader emits a confirmation beep and the green LED
illuminates).
Step 2: Enter the PosiPIN’s [
INSTALLER CODE
] (default:
000000) and press the [
ENTER
] key (reader emits a
confirmation beep and the green LED flashes).
Step 3: Enter section [002] and press the [
ENTER
] key (reader
emits a confirmation beep and the green LED stops
flashing).
Step 4: Press the [0] key (8-bit-Wiegand) and press the
[
ENTER
] key (reader emits a confirmation beep and
the green LED flashes).
Step 5: Press and hold the [
CLEAR
] key for 4 seconds to exit
programming mode (the reader emits a rejection
beep and the green LED extinguishes).
For more information, please refer to the PosiPIN Installation
and Operating Instructions.