BA_PH_3V_EN_07-22.docx
36
11.3
Inserting and Tensioning a Bandsaw Blade
To ensure safe working without incidents, the bandsaw blade must be placed and adjusted properly. For wide
blades, at least two persons are required for this purpose.
Caution: Danger of cutting! Put on protective gloves when changing the bandsaw blade!
•
Unlock the three safety switches for doors (
a
), (
b
) and (
c
) according to section
The doors of the bandsaw can only be opened if the safety switches have been unlocked be-
forehand with the knurled screws (R), see section
11.2. Before the machine can be started
again, the safety switches must first be locked.
Figure 19: Overview - Inserting and tensioning the bandsaw blade
•
Open all three doors (
a
), (
b
) and (
c
) and the blade guard (
8
).
•
Remove chip catcher (
S
) by pulling it out.
•
Loosen the handwheel (
10
) for the band tension and remove the old bandsaw blade if necessary.
•
Place the new blade on the wheels (teeth pointing outwards) and pretension slightly via handwheel (
10
).
•
Turn the brake release switch
to the right “
released
” position
.
•
Now check by turning manually whether the saw blade runs cleanly and centrally and align if necessary.
•
Set the final saw blade tension with the handwheel (
10
) and the pointer (
Z
) of the blade tension indicator.
The blade tension is indicated by the pointer (Z). The blade must be tensioned until the
pointer points to the line that corresponds to the indicated blade width.
Example 30 mm blade
→
The pointer (
Z
) must point to the line belonging to No. 30.
•
Push the chip catcher (
S
) back in and close the blade guard (
8
).
•
Close the doors again, lock the safety switch and turn off the brake release switch.
•
Switch on bandsaw blade and start test run.
10
8
a
b
c
S
Z
Содержание 3V
Страница 2: ...BA_PH_3V_EN_07 22 docx 2 Space for notes...
Страница 4: ...BA_PH_3V_EN_07 22 docx 4 Space for notes...
