BA_PH_3V_EN_07-22.docx
39
11.6.3
Basic Setting of the Back and Side Rollers (Overview)
Figure 24: Basic adjustment of the back and side rollers
The two saw blade guides must be aligned with the
saw blade as follows:
•
The
Figure 24 shows on the far right the optimal
setting of the back and side rollers. On the left and
in the middle, it is shown which settings are wrong
and must be avoided.
•
The back roller must be parallel to the back of the
saw blade (vertical), see
Figure 24 top right.
•
The saw blade must run exactly in front of the inner
edge of the back rollers (
Figure 24, centre right).
•
The side rollers may only touch the saw blade in
the front area.
•
The opening angles between the side rollers and
the saw blade must be the same on both sides
(
Figure 24 bottom right).
•
Both guides must be exactly vertical.
•
After the basic adjustment has been made, tighten
the tommy screws (
K1
) and (
K2
) again.
11.6.4
Conversion to Left Version
Lower Saw Blade Guide:
Figure 25: Convert bottom guide to left
Upper Saw Blade Guide:
Figure 26: Convert top guide to left
•
Loosen both tommy screws
•
Swap the support bolt and the back roller
•
Tighten the tommy screws again
•
Loosen both tommy screws
•
Remove the back roller and the support bolt from the holder
•
Remove the two fastening screws of the support
•
Rotate the holder 180° around its vertical axis
•
Rotate the guide with side rollers 180° around its horizontal axis
•
Screw the holder to the guide again
•
Reinstall the back roller and support bolt and tighten the tommy screws
Содержание 3V
Страница 2: ...BA_PH_3V_EN_07 22 docx 2 Space for notes...
Страница 4: ...BA_PH_3V_EN_07 22 docx 4 Space for notes...
