ID
22
ID
●
SX850 Switch Node and its Domain
For each SX850 switch node, there can be many matrix switch, matrix controller, and matrix OSD devices. In case of
a single domain system, such as the system on page 11, all the matrix controller devices will be assigned to that
domain.
In case of a multiple domain system, the system designer has to decide which domain the matrix controller devices
should belong to.
●
Enter SX850 FRAMES in the WJ-ASC960 Admin Console
After deciding the domain ID for each SX850 matrix controller, the next step is to enter the information in the WJ-
ASC960 Admin Console for the domain.
In the WJ-ASC960 Admin Console,
SX850 FRAMES
screen, we need to configure the devices. Since these devices
are part of the SX850 node, select
SX850
from the
Switch Nodes
command on the
Domain
menu. Following are
the sample data for matrix controller devices:
I/F
IPA
Boot
MXCONT
MXOSD
MXALM
1
1
172.18.0.100
15010426.sr
1-128
1-128
–
MXSW
Input
Output
1-256
1-32
LCPU Address
SW12 SW10 SW9
0
2
0
●
SX650 Switch Node
SX650 switch node consists of one more WJ-SX650 matrix switcher with WJ-PB65E01 network board. SX650
switch node can only be located within a system domain, and cannot cross over multiple domains. Currently, the
system only supports up to one SX650 switch node in a single system domain, and node ID is always set to its
domain ID by the system software.
●
SX650 Switch Node and its Domain
In case of a single domain system, all the WJ-SX650 matrix switcher with WJ-PB65E01 network board will be
assigned to that domain.
In case of a multiple domain system, the system designer has to decide which domain all the WJ-SX650 matrix
switcher with WJ-PB65E01 network board should belong to.
●
Enter SX650 SUBNODES in the WJ-ASC960 Admin Console
After deciding the domain ID for each WJ-SX650 matrix switcher, the next step is to enter the information in the WJ-
ASC960 Admin Console for the domain.
In the WJ-ASC960 Admin Console,
SX650 SUBNODES
screen, we need to configure the devices. Since these
devices are part of the SX650 node, select
SX650
from the
Switch Nodes
command on the
Domain
menu.
Following are the sample data for WJ-SX650 matrix switcher.
EA
IF
IPA
BRIDGE CONTROL
OSD
SWITCH
Input
Output
ALARM
Address [MODE]
5
6
7
8
1
1
172.18.0.100
–
1 - 256
1 - 32
1 - 256 1 - 32
–
OFF
OFF
ON
OFF
00.00.00.00.00.00
