Panasonic PT-RZ31K, Руководство по эксплуатации

Страница: 18 / 265

Chapter 1 Preparation — Precautions for use
18 - ENGLISH
r
Do not use the projector in a location that the ambient temperature exceeds 50 °C
(122 °F).
Using the projector in a location that the altitude is too high or the ambient temperature is too high may reduce the
life of the components or result in malfunctions.
The upper limit of the operating environment temperature differs depending on the altitude or the setting of the
[PROJECTOR SETUP] menu → [OPERATION SETTING] (
x
page 151) → [OPERATING MODE].
Altitude above sea level
Setting for [OPERATING MODE]
[HIGH], [NORMAL], [USER1], [USER2],
[USER3]
[LONG LIFE1], [LONG LIFE2], [LONG LIFE3]
Altitude of 0 m (0') or higher
to lower than 1 400 m
(4 593')
0 °C (32 °F) to 50 °C (122 °F)
0 °C (32 °F) to 45 °C (113 °F)
Altitude of 1 400 m (4 593')
or higher to lower than
2 700 m (8 858')
0 °C (32 °F) to 45 °C (113 °F)
Altitude of 2 700 m (8 858')
or higher to lower than
4 200 m (13 780')
The projector cannot be used.
When the Smoke Cut Filter is used, the operating environment temperature should be between 0 °C (32 °F) and
40 °C (104 °F) regardless of the [OPERATING MODE] setting. It cannot be used at an altitude of 1 400 m (4 593')
or higher above sea level.
r
Projection in all 360° direction is possible.
360°
360°
360°
360° vertically 360° horizontally 360° tilted
(combination of vertical and horizontal)
Cautions when setting up the projector
f
Install the projector in a place or with a mount that can sufficiently tolerate the weight. The position of the
projected image may shift if the strength is not sufficient.
f
Use the adjustable feet only for the floor standing installation and for adjusting the angle. Using them for other
purposes may damage the projector.
f
The adjustable feet can be removed if not needed in the installation. However, do not use the screw holes
where the adjustable feet were removed to fix the projector to a mount.
Also, do not insert any screws other than the eyebolts for the installation work into the screw holes of the
adjustable feet. Do not insert the removed adjustable feet into other M10 screw holes.
f
Do not fix the projector to a mount with the screw holes for eyebolts (4 locations on each side) on the top side,
right and left sides, and back side.
f
When installing and using the projector in a method other than the floor installation using the adjustable feet,
remove the adjustable feet (4 locations) and use the six screw holes to fix the projector to a mount (as shown in
the figure).
For the screws to fix the projector, use commercially available ISO 898-1 standard screws (made of carbon steel
or alloy steel).
(Screw diameter: M10, thread engagement length: 18 mm (23/32") or more, tapping depth inside the projector:
30 mm (1-3/16"))