Panasonic PT-RZ31K, Руководство по эксплуатации

Страница: 166 / 265

Chapter 4 Settings — [PROJECTOR SETUP] menu
166 - ENGLISH
Note
f
When [INPUT SELECT] is set to [DIGITAL LINK], communication using that serial terminal is available only when the corresponding device
(such as the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G)) is connected to the <DIGITAL LINK/
LAN> terminal.
f
When transferring logos via the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G), setting for “NO
SIGNAL SLEEP” of the DIGITAL LINK output supported device should be set to “OFF” to avoid interruption of communication.
f
When [INPUT SELECT] is set to [DIGITAL LINK], communication speed for input is fixed to 9 600 bps and the parity is fixed to “NONE”.
[REMOTE2 MODE]
You can set the <REMOTE 2 IN> terminal.
1) Press
as
to select [REMOTE2 MODE].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[DEFAULT]
Uses pin assignment of the <REMOTE 2 IN> terminal in standard setting. (
x
page 240)
[USER] Changes the setting of the <REMOTE 2 IN> terminal.
f
When [USER] is selected, proceed to Step
3)
.
3) Press the <ENTER> button.
4) Press
as
to select one from [PIN2] to [PIN8], and press
qw
to switch the setting.
[FUNCTION BUTTON]
Set the function of the <FUNCTION> button on the remote control.
1) Press
as
to select [FUNCTION BUTTON].
2) Press the <ENTER> button.
f
The [FUNCTION BUTTON] screen is displayed.
3) Press
as
to select a function.
[DISABLE]
Disables the <FUNCTION> button.
[P IN P] Switches the [P IN P] setting ([OFF], [USER1], [USER2], or [USER3]). (
x
page 172)
[SUB MEMORY]
Displays the sub memory list. (
x
page 177)
[SYSTEM SELECTOR]
Switches the [SYSTEM SELECTOR] setting according to the input signal of the image being
projected.
f
When the input signal is anything other than SDI1 input or SDI2 input
The [PICTURE] menu
→ [SYSTEM SELECTOR] (
x
page 97)
f
When the input signal is SDI1 input or SDI2 input
g
The [DISPLAY OPTION] menu → [SDI IN] → [SINGLE LINK SETTING] → [SDI1]/[SDI2] →
[SYSTEM SELECTOR] (
x
page 129)
g
The [DISPLAY OPTION] menu → [SDI IN] → [DUAL LINK SETTING] → [SYSTEM SELECTOR]
(
x
page 129)
[SYSTEM DAYLIGHT VIEW]
Switches the [SYSTEM DAYLIGHT VIEW] setting. (
x
page 94)
[FREEZE]
Temporarily pauses the image. (
x
page 136)
[WAVEFORM MONITOR]
Displays the waveform of the input signal. (
x
page 136)
[LENS MEMORY LOAD] Loads the registered lens memory. (
x
page 141)
[LEFT/RIGHT SWAP]
Switches the [LEFT/RIGHT SWAP] setting. (
x
page 113)
[PROJECTION METHOD]
Switches the [PROJECTION METHOD] setting. (
x
page 138)
4) Press the <ENTER> button.
[STATUS]
Display the status of the projector.
1) Press
as
to select [STATUS].
2) Press the <ENTER> button.
f
The [STATUS] screen is displayed.