Panasonic PT-MZ670, Руководство по эксплуатации

Страница: 216 / 228

Chapter 7 Appendix — Technical information
216 - ENGLISH
<REMOTE 1 IN> terminal
The projector can be remotely controlled (contact control) by the control board that is located far away form the
projector where the signal from the remote control does not reach.
Use the <REMOTE 1 IN> terminal on the connecting terminals of the projector to connect to the control board.
Remote control Contact control
Remote control/contact control
Standby Lit
Light source
RGB1 HDMI1
RGB2 HDMI2
VIDEO
Installation locations in meeting rooms, etc. Remote control board in another location
Pin assignments and signal names
D-Sub 9-pin
Outside view
Pin No. Signal name Open (H) Short (L)
(1) (5)
(6) (9)
(1) GND ― GND
(2) POWER OFF ON
(3) RGB1 Other RGB1
(4) RGB2 Other RGB2
(5) VIDEO Other VIDEO
(6) HDMI1 Other HDMI1
(7) HDMI2 Other HDMI2
(8) SHUTTER OFF ON
(9) RST/SET
Controlled by remote
control
Controlled by external
contact
Attention
f
When controlling, make sure to short-circuit pins (1) and (9).
f
When pins (1) and (9) are short-circuited, the following buttons on the control panel and the remote control are disabled. Commands for
RS-232C and network functions corresponding to these functions are also disabled.
g
Power <
v
/
b
> button, <SHUTTER> button
f
When pins (1) and (9) are short-circuited, and then any pins from (3) to (7) and the pin (1) are short-circuited, the following buttons on the
control panel and the remote control are disabled. Commands for RS-232C and network functions corresponding to these functions are also
disabled.
g
Power <
v
/
b
> button, <INPUT SELECT> button, <RGB1/2> button, <HDMI 1> button, <HDMI 2> button, <DIGITAL LINK> button,
<VIDEO> button, <NETWORK/USB> button, <SHUTTER> button
Note
f
Setting of the pin (2) to pin (8) can be changed when the [PROJECTOR SETUP] menu → [REMOTE1 MODE] is set to [USER].
(
x
page 121)
Operating [MENU LOCK PASSWORD]
To return the password to the factory default setting (AAAA), perform following operation while displaying the
[MENU LOCK PASSWORD] input request screen.
1) Press the <AUTO SETUP/CANCEL> button on the remote control for at least three seconds.
2) Press
s
for at least three seconds.