Panasonic PT-MZ670, Руководство по эксплуатации

Страница: 33 / 228

Chapter 1 Preparation — Preparing the remote control
ENGLISH - 33
Preparing the remote control
Inserting and removing the batteries
(ii)
(i)
Fig. 1 Fig. 2
1) Open the cover. (Fig. 1)
2) Insert the batteries and close the cover (insert the
m
side first). (Fig. 2)
f
When removing the batteries, perform the steps in reverse order.
When using the multiple projectors
When you use the multiple projectors together, you can operate all the projectors simultaneously or each projector
individually using single remote control, if a unique ID number is assigned to each projector.
When using the projectors by setting the ID numbers, set the ID number of the projector body after initial settings
have been completed. Then, set the ID number of the remote control. For initial settings, refer to “When the initial
setting screen is displayed” (
x
page 60).
The factory default ID number of the projector (projector body and remote control) is set to [ALL], so you can use
it as it is. Set the ID numbers of the projector body and remote control as necessary.
For details on setting the ID number of the remote control, refer to “Setting ID number of the remote control”
(
x
page 76).
Note
f
Set the ID number of the projector body from the [PROJECTOR SETUP] menu → [PROJECTOR ID].
Connecting the remote control to the projector with a cable
To control the projector with a wired remote control, connect the remote control wired terminal of the remote
control with the <REMOTE 2 IN> terminal of the projector with commercially available M3 stereo mini plug cable.
This is effective when using the projector in location where there is an obstacle between the projector and the
remote control or location that is affected by the outside light.
f
The wireless remote control cannot be used when a cable is connected to the <REMOTE 2 IN> terminal of the
projector.
Connecting terminals
M3 stereo mini jack cable (commercially
available)
Remote control
Connecting to the remote control wired terminal
Attention
f
Use a cable that is 15 m (49'3") or shorter, with 2 core shielded. The remote control may not operate when the length of the cable exceeds
15 m (49'3") or when the shielding of the cable is inadequate.