No. SX-DSV03015 - 57 -
Motor Business Unit, Panasonic Corporation
SAFETY PRECAUTIONS
10. Safety precautions
■ Danger and damage caused when the safety precautions are ignored are described in the following categories and
signs:
Description of this sign indicates “urgent danger that may cause death or serious injury. ”
Description of this sign indicates “danger that may cause injury or property damage. ”
■ Rules to keep are categorized and described with the following graphics.
This graphic indicates “Prohibited” acts that are not permitted.
This graphic indicates “Mandatory” acts that must be performed forcibly.
(1)
Be sure not to store or use the equipment under conditions subjected to vibrations (5. 88 m/s
2
or heavier) or
an impact shock, foreign matters such as dust, metal particles oil mist, liquids such as water, oil and
polishing liquid, near flammable objects, in an atmosphere of corrosive gas (such as H
2
S, SO
2
, NO
2
, Cl
2
) or
in an atmosphere of flammable gas.
(2)
Do not place any flammable objects near a motor, a driver, or a regenerative resistor.
(3)
Do not driver the motor with external torque. Motor generates electricity by external torque.
Dynamic brake circuit will be damaged and it is possible that short-circuit current cause smoke or combustion.
(4)
Do not damage or strain the cable, or do not apply excessive stress. Do not place a heavy item on the cable
or do not pinch the cable.
(5)
Do not use the equipment with the cable soaked in oil or water.
(6)
Do not install the equipment near a heating object such as a heater or a large wire-wound resistor.
(Install a thermal shield, etc. to avoid the influences of heating object.)
(7)
Do not connect the motor directly with a commercial power.
(8)
Do not use the equipment under conditions subject to strong vibrations or an impact shock.Please attach the
anti-vibration equipment to servo driver mounting surface If you install the servo driver in the vicinity of
the vibration source.
(9)
Be sure not to touch a rotating part of a motor during operation.
(10)
Do not touch the key flutes of motor output shaft with bare hands.
(11)
Be sure not to touch inside a servo driver.
(12)
Motor drive heat sink and peripheral device become very hot. Do not touch them.
(13)
Do not carry out wiring or do not operate the equipment with wet hands.
DANGER
DANGER
ATTENTION
