Panasonic FP-M Hardware, Руководство пользователя

Страница: 162 / 268

■
Construction of DT9120
This area specifies the control modes for the high-speed counter board.
*1. Output mode:
*2. External reset control bit:
*3. Target setting:
To preset the target values for the high-speed counter board, first, transfer the set values to the special data registers for
the target values. Then, turn the target setting bit from 0 to 1. A set value is revised at the moment the leading edge of
this bit is detected. Therefore, if the bit is already set to 1, change the bit from 1 to 0 and then change it back to 1.
*4. Number system selection:
This bit is prepared to select the number system used for the high-speed counter board. If you set this bit to 0, the
data counts the number in the BCD code. However, the FP-M usually handles numbers in binary, so use of the
binary number system is recommended.
ON
OFF
Reset inputs become effective
ON
OFF
External reset control bit
(bit positions 3 and 11)
ON
OFF
External reset enable input
(RST.E0/RST.E1)
External reset input
(RST.0/RST.1)
By turning ON the external reset enable
inputs (RST.E0/RST.E1), you can enable
the external reset inputs (RST.0/RST.1).
The external reset inputs (RST.0/RST.1)
effective are:
- external reset inputs while the external
reset enable input is in the ON states.
- the first external reset inputs after the
external reset enable input turns OFF.
Reset inputs ignored
ON
OFF
External reset control bit
(bit positions 3 and 11)
ON
OFF
External reset input
(RST.0/RST.1)
These bits (bit positions 3 and 11) are in the
ON state, the external reset inputs
(RST.0/RST.1) are ignored as:
Bit
position
0
1
8
9
Channel
0
1
Corresponding
target value
Target 0
Target 1
Target 0
Target 1
Corresponding
output
OUT00
OUT01
OUT10
OUT11
Bit data 0: OFF
→
ON
1: ON
→
OFF
The output goes ON or OFF when the
elapsed value becomes equal to the target.
These bits specify the mode for output
transition when the elapsed value
becomes equal to the target value. If the
output mode is changed, set the target
value again.
11 8 3 0 15
• •
12
• • • •
7 4
• •
Bit position
Data
CH0 Output mode for target
*
1
  
CH0 Internal reset control bit (1: reset)
CH0 External reset control bit (1: disabled) * 2
CH0 “Target = Elapsed” output control bit (1: disabled)
0 0 1 0
CH0 Target setting bit (1: set) * 3
Number system selection * 4
Set this bit to 1 (BIN number system)
CH1 Output mode for target * 1
  
CH1 Internal reset control bit (1: reset)
CH1 External reset control bit (1: disabled) * 2
CH1 “Target = Elapsed” output control bit (1: disabled)
CH1 Target setting bit (1: set) * 3
154
7-5. High-speed Counter Board