Panasonic EBL512 G3 V1.1.x, Руководство по эксплуатации

Страница: 115 / 162

Panasonic Electric Works Nordic AB
MEW01349 Rev: - Operating Instructions Fire alarm system EBL512 G3, V1.1.x
113
27.7 Show information (H4/U7)
Menu H4/U7 can be used to show the following information for the
specific control unit you currently use:
Main board version The S/W (system program) version of the Main
board 5010.
MMI board version The S/W (system program) version of the MMI
board 5011.
Alarm counter The alarm counter is increased with "1" every time
the c.i.e. enters a real "fire alarm condition" (Fire alarm indication in
the display, LEDs "Fire" are lit and the c.i.e. buzzer is sounding), i.e.
not for zones in test mode. It starts on 000 and goes to 999. It can be
reset to 000 via WinG3 (Control unit menu "Reset alarm counter…").
It is stored in an EEPROM, i.e. the value will be retained also after the
c.i.e. has been de-energized.
Max. number of allowed alarm points that can be used in this
control unit, i.e. 128, 256 or 512.
Note, that max. number of COM loop addresses is always 1020 .
Convention Different countries have different conventions, i.e.
country specific functions, default settings, etc. The convention is set
in conjunction with the installation of WinG3. (The convention can, if
required, be changed via WinG3).
54
Serial number The manufacturer's serial number (year, month,
number).
Installation name As written in the WinG3 dialog box "System
Properties" (Name).
Date and time when the site specific data (SSD) was downloaded.
Control unit number 00-29.
Action Text in display Comments
"Menu"
According to chapter
"Access", see page 85.
Scroll to menu H4. H4 Present system status
"
↵
"
U1 Disablement
U2 Disablement by time channel
U3 Open doors
U4 Sensor values
U5 Sensors activating SERVICE signal
U6 Event log
U7 Information
54
To change the convention in WinG3, "Level 2" has to be selected, which
require a special password.