Panasonic DP-C321, Руководство по обслуживанию

Страница: 31 / 548

2-6
Chapter 2 Maintenance
ADJ1. 1. 3 DC922 TRC Control
Purpose To check that the output of ATC Sensor and TC Control performed normally. Provides
the TONE UP/DOWN function (calculates the increase and decrease of the toner by the difference
of the ATC Sensor output and standard value, or performing UP/DOWN by inputting the value
manually) as a restoring function when TC does not operate normally.
76 799 160
77 844 156
78 889 152
79 934 148
80 526 185
81 572 182
82 617 178
83 663 174
84 708 170
85 753 166
86 799 162
87 844 158
88 889 154
89 934 150
90 526 187
91 572 184
92 617 180
93 663 176
94 708 172
95 753 168
96 799 164
97 844 160
98 889 156
99 934 152
Bar Code No.
(Last 2-digit)
Sensitivity Slant Initial Value
Standard TC Output Initial
Value
• Check that LTR paper (LEF) is loaded in Tray 1 since TONE UP/DOWN uses
paper.
• Do not put a value in the DC922 TRC Control, if the ATC Sensor Failure
09-380~09-383 occurs, when the value for DC131 [752-324] (SW_DispMODE) is
set "0".
To enter the Diag, change the value of DC131 [752-324](SW_DispMODE] to either
of "1, 2" and execute this Diag.
When completing the operation after the ATC Sensor (UI screen indicates
"ATC_OK") turns normal, return the value of
DC131 [752-324](SW_DispMODE)
to "0" (Normal Mode).
*When using the abnormal ATC Sensor temporarily, keep the value "1, 2".
• The relations between the value of DC131 [752_324] (SW_DispMODE) and the
DISP Mode are described in the table below.
Value of DC131 [752-324]
(SW_DispMODE)
Disp Mode
0 ATC+ICDC Mode (Normal Mode)
1 ICDC MODE
2 Timer Disp Mode