Panasonic AK-MSU935AP, Руководство по эксплуатации

Страница: 72 / 76

72
Restrictions on the operation of the ALL switch
The ALL function is used to send the same control commands to all the cameras which are connected to the MSU.
An overview of the specifications of the ALL function is presented below.

The function takes effect for the MSU operations performed while the ALL switch is pressed.
 The function supports the following switch operations only.
HD.DTL OFF, SD.DTL OFF, KNEE OFF, BAR, CLOSE, TEST, GAIN, FILTER and AUTO

All switch operations other than the above take effect only for the camera which was under control immediately before the
ALL switch was pressed.

Even while the ALL switch is pressed, it is still possible to control each of the cameras from the ROPs connected to those
cameras.
 The operations of the ROP connected to the camera which was under control immediately before the ALL switch was pressed
are reflected on the MSU panel display.
The control
commands are sent
to all the cameras.
MSU status display
is changed.
During normal
operations
Control commands
are sent to the camera
under control
How the statuses change during ALL operations
ALL switch pressed ALL switch pressed
After the control
commands have been
sent, the original
status is restored.
Operations
performed by the
ROP of the camera
now under control
After the control
commands have
been sent, the
original status is
restored.
Operations
other than the
ones listed on
the right
Operation performed by any
ROP other than the above
The following switches are pressed.
HD.DTL OFF
SD.DTL OFF
KNEE OFF
TEST
BAR
CLOSE
Any automatic operation switches
Any filter selection switches
Any gain selection switches
The number of the
camera now under
control flashes, and
the other camera
numbers are lighted.
The status of the
camera itself changes
but the MSU status
remains unchanged.
• If cameras of different models exist, the operation will be performed for only the cameras of the same model as the selected
camera.