Panasonic AJ-CX4000G, Руководство по эксплуатации

Страница: 85 / 221

– 85 –
Chapter 4 Operation — Menu settings
[1280 × 720p] Outputs in 1280 × 720p.
[720 × 480i] Outputs in 720 × 480i.
[720 × 576i] Outputs in 720 × 576i.
(Factory setting: [1920 × 1080i])
@ @
NOTE
t For the combinations that can be set, refer to “Format that can be output from the <SDI OUT2> terminal” (page 178).
[3G-SDI OUT]
Sets the format of the 3G-SDI signal output from the <SDI OUT2> terminal.
Can be set when the 3G-SDI signal is output.
[LEVEL-A] Selects the LEVEL-A method.
[LEVEL-B] Selects the LEVEL-B DL method.
(Factory setting: [LEVEL-B])
[SD-SDI EDH]
Sets whether to superimpose EDH when output from the <SDI OUT2> terminal is the SD signal (480i and 576i).
[ON] Superimposes.
[OFF] Does not superimpose.
(Factory setting: [ON])
[SDI REC REMOTE]
Sets if the recording operation against the external equipment connected to the <SDI OUT2> terminal (such as recorder) is to be controlled or not.
[ON] Controls the recording operation of the external equipment.
[OFF] Does not control the recording operation of the external equipment.
(Factory setting: [OFF])
@ @
NOTE
t This cannot be set when set to the [RECORDING] menu → [REC FUNCTION] → [REC MODE] → [INTERVAL].
[SDI OUT ZEBRA]
Sets whether to superimpose the zebra signal to the output from the <SDI OUT2> terminal.
The setting of the zebra signal is in accordance with the following setting in the [VIDEO OUT/LCD/VF] menu
→ [EI ASSIST].
f [ZEBRA1 DETECT], [ZEBRA2 DETECT], [ZEBRA2]
[ON] Superimposes.
[OFF] Does not superimpose.
(Factory setting: [OFF])
[SDI OUT HDR]
Sets the signal to output from the <SDI OUT2> terminal.
[SDR] Outputs in the standard dynamic range.
[HDR] Outputs in the high dynamic range.
(Factory setting: [HDR])
@ @
NOTE
t The setting is fixed to [SDR] when set to the following menu.
- [VIDEO OUT/LCD/VF] menu
→ [SDI OUT2] → [OUT FORMAT] → [720 × 480i]
- [VIDEO OUT/LCD/VF] menu → [SDI OUT2] → [OUT FORMAT] → [720 × 576i]
t The camera image is output in the standard dynamic range when the [SCENE FILE] menu → [GAMMA MODE SEL] is set to anything other than
[HLG].
[MARKER SW]
Marker is displayed in the output from the <SDI OUT2> terminal.
The items that can be set are as follows.
f [ON], [OFF]
(Factory setting: [OFF])
[SDI OUTPUT ITEM]
Sets the character content to superimpose on the output signal of the <SDI OUT1>/<SDI OUT2>/<HDMI> terminals.
[MENU ONLY] Superimposes only the menu when displaying the menu. Normally, nothing is superimposed.
[TC] Superimposes the time code. Superimposes only the menu when displaying the menu.
[STATUS] Displays the same contents as all the characters displayed in the viewfinder and the LCD monitor. Superimposes only the
menu when displaying the menu.