16
Main Mode: Thumbnail Screen
4
When the cursor is in the lower half of the monitor,
use the Left/Right cursor buttons to select the
thumbnail with the text memo you want to play and
press the PLAY
button.
The clip is played back from the text memo time code
location selected with the cursor. When you press the
STOP
button to interrupt ongoing playback, or when
playback stops upon reaching the end of the clip, the
thumbnail screen reappears and the cursor returns to the
thumbnail text memo location where playback was
started. Press the EXIT button to return the cursor to the
top of the thumbnail screen.
◆
NOTE:
• During playback all buttons other than the STOP
button are
not available.
Select clips you want to process on the thumbnail screen.
1
Use the Up/Down/Left/Right cursor buttons to place
the yellow frame (cursor) on the desired clip.
◆
NOTE:
• Press the TOP/BOTTOM button to move the cursor to the first or
last clip.
2
Press the SET button.
A blue frame appears on the clip selected with the cursor
to indicate that it is selected.
◆
NOTE:
• Repeat steps 1 and 2 to select multiple clips.
• After selecting a clip, move the cursor to another clip, hold down
the SHIFT button and press the SET button to select another
clip. This method allows you to select the two clips as well as all
the clips between them.
• Selecting a clip updates the number of selected clips shown in
the lower right corner of the screen.
1
Place the cursor on a selected clip and press the SET
button again.
This cancels the selection.
◆
NOTE:
• Press the CANCEL button to deselect selected clips.
A text memo can be attached in a clip to mark a specific
location. The user can attach shot marks to distinguish clips
from each other. Clips on P2 cards where the write-protect
switch is set to PROTECT cannot be added.
Selecting and Deselecting Clips
Selecting clips
2
1
Deselecting clips
Attaching Text Memos and Shot
Marks
1
