Palax KS45S, Руководство пользователя

Страница: 35 / 38

35
Palax KS45s Translation 1-2017
8.
Malfunctions and their remedy
Disturbance Cause Remedy
Splitting is not operational 1. Protective net for splitting
chute is open.
2. No oil or too little oil.
3. Debris inside the launch
system.
4. The oil is too cold.
5. A hydraulic hose has burst
or is leaking.
6. The splitting system does
not move due to freezing.
1. Close the protective net.
2. Stop the machine immediately
and top up the oil.
3. Clean up the launch system.
4. Allow the oil to circulate at free-
flow for a few minutes.
5. Replace the hose.
6. Always clean the machine when
you stop working.
The splitting movement does
not stop, when the protective
net is opened.
1. The setting of the locking
device has moved out of
position or the locking
device is broken.
1. Adjust the locking device or
replace the faulty part.
Slow or powerless splitting
movement.
1. The oil is too cold.
2. No oil or too little oil.
1. Allow the oil to circulate at free-
flow for a few minutes.
2. Top up oil.
The log does not split. 1. Incorrect position of the
wedge.
2. A large branch at the
splitting point.
3. Exceeds the upper limit for
the machine.
4. The oil pressure has
dropped.
1. Adjust the height of the wedge.
2. Stop the machine, open the
splitting cover, rotate the log,
and close the splitting cover.
3. Maximum thickness 43 cm.
4. Check the hydraulic system.
The crosscut saw cuts poorly. 1. The blade is dull. 1. Sharpen or replace the chain.
The saw-chain clashes with the
saw-cover.
1. The bolts of the bearings
supporting the saw-shaft
have loosened. The saw-
shaft in an oblique position.
1. Straighten the saw-shaft and
tighten the bolts.
The conveyor belt is running at
the side.
1. The setting has moved out
of position.
1. Adjust the return rollers at the
end of the conveyor. Test run
after the adjustment.
The log gets stuck in the
splitting wedge.
1. Incorrect length of splitting
stroke.
2. Blunt splitting wedge.
1. Extend the stroke.
2. Sharpen the saw-blade.
The log rises up during splitting. 1. Crooked or knotty tree.
2. Stroke of the pusher is too
short.
1. Correct the position of the log.
2. Check the stroke length of the
pusher.
The log clashes with the
bottom of the conveyor.
1. The conveyor stands too
upright.
1. Reduce the rise angle of the
conveyor.