Palax KS45S, Руководство пользователя

Страница: 28 / 38

28
Palax KS45s Translation 1-2017
6. Maintenance of the machine
Note! Always stop the machine and disconnect it from the power source before
performing any service measures.
If a service measure requires the power source to be running, particular caution must be
exercised!
After completing the service measures, and before starting the
operation, fasten all the protective covers in place, ensure that the
protective devices are in order and test run the machine in
accordance with the instructions in point 3.2.
Removing the protective covers, Fig. 6.1
Loosen the attachment screws of the protective
covers (A) a few centimetres, and lift off the covers.
The attachment screws need not be taken away for
removal of the protective covers.
Crosscut saw-blade
Changing and tightening the saw-chain, Fig. 6.2

Open the protective net.

To tighten the saw-chain, loosen the attachment
nuts (1) of the saw-bar (Fig. 6.2) and turn the
tightening bolt (2) clockwise.

To remove the saw-chain, turn the tightening
bolt (2) counter-clockwise until the chain
slackens.

The chain needs to be tightened enough to
prevent it from sagging under the saw-bar.

Finally, tighten the attachment nuts of the saw-
bar.

Check the chain for tightness at regular intervals.
6.2
1
2

Working with a blunt or damaged saw-chain is utterly uneconomical. Clean up and check the
saw-chain. Make sure that there are no cracks in the chain links and that all the rivets are
intact. If the chain is damaged or worn out, it must be replaced.
Servicing the saw-chain

If the saw-chain will not be used for a while, clean it up using a brush and immerse it in an oil
bath.

Always after re-sharpening, clean up the saw-chain thoroughly, remove from it any stuck chips
or grinding dust and immerse it in oil.
Cutting teeth

Use only special saw-chain files!

Saw-chain pitch 0.404"; gauge 1.6 mm; length 71 links.

Checking the saw-chain pitch: t = the distance over three rivets divided by two.