Palax KS45S, Руководство пользователя

Страница: 29 / 38

29
Palax KS45s Translation 1-2017

The standard filing angle is 30˚.

The angles must be the same on all the cutters of the saw-chain. If the angles are uneven, the
saw-chain will rotate unevenly, will wear more quickly and may even break.

All cutters must be the same length. If the cutters are not the same length, they will have
different heights. This makes the chain run roughly and possibly crack.

The required sharpening results can be met only after sufficient and constant practice. Use a
file holder! As required, turn to a professional.
Servicing the saw-bar

Always turn the saw-bar over, file its side and clean its groove when necessary.
6.1. Changing the angular gear oil, Fig. 6.3

Loosen the attachment screws of the
lower cover at the rear of the
machine, and remove the cover.

The oil plugs are located in the side of
the angular gear. Filling 1 and
drainage 2, Fig. 6.3.

The angular gear must be demounted
for the oil change, or the used oil
must be drained, for example, by
means of suction drainage.

Fill up with about 1 litre of new oil.

The upper limit is at the lower edge of
the filling opening.

Oil type SAE 80.
Lubricating the machine

See the service schedule. Many of the bearings are lubed-for-life and do not need to be
lubricated. If a lubed-for-life bearing receives too much lubricant, its gasket may get damaged.
NOTE ! If the machine is left standing for a longer period of time, it is important that the
bearings always be provided with clean lubricant.

If the machine is used regularly, lubricate the bearings once a week.

Oil the moving joints daily.