Palax KS45S, Руководство пользователя

Страница: 20 / 38

20
Palax KS45s Translation 1-2017
3.7. Powered by tractor

The tractor-powered machine must always be hitched to the tractor’s lifting arms. This ensures
that the distance between the firewood processor and the tractor stays correct. If it changes
during operation, severe damage might result.

Usually, the machine is delivered with the attachment lug removed. The log shall be attached
by the customer.

A suitable power take-off shaft is, for example, BONDIOLI A 143 or WALTERSCHEID W 2300.

No safety clutch is required for the PTO shaft.

Only use fault-free PTO shafts and always attach the chains for the shaft-guard to the machine
(Fig. 3.3, B).

Start the tractor and switch on its PTO at low revolutions, after that increase the revolutions to
450-500 r.p.m.

The machine comes with towing pins of 28 mm.
3.8. The machine is equipped with a system to
prevent simultaneous operation in two
modes, Fig. 3.3

When the cover plate A is turned down, it is possible to
connect the extension cord. When the cover is raised up, it
is possible to connect the PTO shaft.

Attachment point B for the guard of the PTO shaft
WARNING! Never remove from the machine the plate that
prevents the simultaneous operation in two modes.
Always remove the PTO shaft before operating the machine
by electricity.
3.9. Adjusting the log length, Fig. 3.4

The length of the log is adjusted by shifting
the log length limiter.

Remove the bolt A, and shift the log length
limiter to the desired position on the scale
B.