Pace TF 500, Инструкция по установке и эксплуатации

Страница: 8 / 31

4
Advanced Placement Platform
Installation
The Advanced Placement Platform (including Fine Adjustment Table) is provided with each TF 700 ThermoFlo
System. Use the following instructions and accompanying illustrations as a guide to assemble the Advanced
Placement Platform.
1. Place the Base upside down on a work surface and install the 4 Rubber Feet (with built-in screws) at
the corners of the Base.
2. Turn the Base over and position as shown.
3. There are 2 Alignment Pins located on the bottom of the Spacer. Insert the 2 Alignment Pins fully into
the 2 Alignment Holes in the Base.
4. There are 2 Alignment Pins located on the bottom of the Support Arm. Insert the 2 Alignment Pins
fully into the 2 Alignment Holes in the Spacer.
5. Install the 4 long Mounting Bolts and Lock Washers. Tighten each bolt to secure the Support Arm and
Spacer to the Base.
6. Place the Fine Adjustment Table in position on the Base. Align the 4 threaded Mounting Holes in the
center of the Base with the 4 Mounting Holes of the Fine Adjustment Table.
7. Secure Fine Adjustment Table to the Base using the 4 short Mounting Bolts, Lockwashers & Flat Washers.
8. The 4 mounting screws that secure the ends of the 2 metal slide rods in position together may loosen
during shipment. Loosen all 4 mounting screws and perform the following procedure.
a) Move the Clamp Assemblies to the ends of the metal slide rods.
b) Move the metal slide rods to their Right side limit and tighten the 2 mounting screws on the Left
side ends of the metal slide rods. NOTE: You may need to loosen the X-Axis Lock.
c) Move the metal slide rods to their Left side limit and tighten the 2 mounting screws on the Right
side ends of the metal slide rods.
9. Insert one end of the supplied Ground Cable into the Base as shown or into either of the 2 Ground
Jacks at the front, right side of the Base.
10. Install the Y-Axis Stops into the Clamp Assemblies as shown. One of the Y-Axis Stops has a longer
curved "L" section than the other. This larger stop should be installed onto the left side of the Fine
Adjustment Table (facing as shown in illustration).
Operation
Vertical Slide Assembly
The Vertical Slide Assembly holds the ThermoFlo handpiece in a vertical position for precise component removal and
installation operations. Refer to the Handpiece Installation procedure to properly install the handpiece.
Simply rotate either of the Vertical Control Knobs to raise or lower an installed ThermoFlo handpiece (with
attached nozzle). Refer to "ThermoFlo Handpiece" "Operation" for additional information.