Pace TF 500, Инструкция по установке и эксплуатации

Страница: 20 / 31

16
Introduction
The following procedures detail the steps required to install and operate any of the ThermoFlo vision accessories.
The Precision Swivel is supplied with each vision system purchased. Install the Precision Swivel and then install
your Lens Vision or Camera Vision Attachment using the applicable procedure.
Precision Swivel
Installation
Installation of this accessory is required before installing a Lens Vision or Camera Vision Attachment. . Use the
following instructions and accompanying illustrations as a guide to install the Precision Swivel.
Vision Systems
1. The Precision Swivel is supplied with its 2 Mounting Screws secured with 2 hex nuts to hold the
Spacer in place during shipment. Remove the 2 hex nuts and hold the Spacer, Precision Swivel and
Mounting Screws together.
2. Ensure that the Support Bracket is positioned as shown, opposite (180° from) the Mounting Screws. If
not, turn the Precision Swivel to place the Support Bracket in the proper position.
3. Place the Precision Swivel (with Spacer) in position on the Vertical Slide as shown with the 2
Mounting Screws aligned with the 2 mounting holes on the Vertical Slide.
4. Insert the 2 Mounting Screws into the 2 mounting holes on the Vertical Slide. Tighten the screws to
secure the Precision Swivel on the Vertical Slide.
5. Move the Vertical Slide up and down through its full range of travel to ensurefree movement. If the
Clearance Limiter Assembly Locking Knob hits the Precision Swivel, loosen the 2 Mounting Screws
and align the Precision Swivel to clear the Locking Knob. Tighten Mounting Screws to secure in
position.