Pace TF 500, Инструкция по установке и эксплуатации

Страница: 24 / 31

20
Camera Vision Attachment
Installation
Use the following instructions and accompanying illustrations as a guide to install the Camera Vision Attachment,
part number 6018-0102 (NTSC) or 6018-0103 (PAL).
1. Position the Camera Mounting Bracket on the Camera as shown. Secure in position using the 2 hex
head Mounting Bolts and Lockwashers.
2. Screw the Camera Lens onto the Camera.
3. Remove the Clamp Screw from the end of the Support Shaft Assembly.
4. Hold the Support Shaft Assembly with the flat portion of the rod on the right side. Insert the rod end
of the Support Shaft Assembly up through the hole in the Pivot.
5. Tighten the Shaft Locking Knob to secure the Support Shaft Assembly in position.
6. Position the Camera (with Camera Mounting Bracket) on the Support Shaft Assembly as shown with the
holes in the Camera Mounting Bracket aligned with the mounting holes in the Support Shaft Assembly.
7. Insert the 2 enclosed Mounting Screws through the Camera Mounting Bracket and into the mounting
holes on the Support Shaft Assembly. Tighten the screws to secure the Camera in position.
8. Plug one end of your Video Cable (RG59/U type - not supplied by PACE) into the video connector at
the rear of the Camera.
9. Plug the free end of the Video Cable into your video monitor (75 ohm input). PACE does not provide
a monitor.
NOTE
A Camera Power Supply is provided with the NTSC system (part number
6018-0102); a supply is not provided with the PAL version (part number
6018-0103). When purchasing a Camera Power Supply for a PAL version,
it must comply with the following requirements:
12 V DC Output, 500ma. Current Rating
Cable terminates with Mini-Plug, 5.5mm O.D., 2.1mm I.D., Center Positive
10. Plug the Camera Power Supply cable mini-plug into the power connector at the rear of the Camera.
11. Wrap the supplied length of plastic Spiral Wrap around both the Video and Camera Power Supply
Cables. Begin at a point approximately 10.2cm (4 inches) from the Camera connections.
12. Place the Clamp over the cables & Spiral Wrap as shown.
13. Install the Clamp Screw (removed in step 3) through the Clamp and into the end of the Shaft Support
Assembly. Do not tighten the screw.
14. Adjust the cables and Spiral Wrap for best use. Rotate the Camera around the Precision Swivel to
ensure that dress of cables allows free movement. Tighten Clamp Screw to secure cables in position.
Vision Systems