Pace TF 500, Инструкция по установке и эксплуатации

Страница: 11 / 31

7
Fine Adjustment Work Platform
e) Turn the Theta Lock knob (item
Ç
) counterclockwise to loosen. Grasp the ends of the metal slide
rods; push one end while pulling the other to rotate table. Rotate table until component/land
pattern is square to nozzle. Turn Theta Lock knob clockwise to lock table in position.
d) Adjust the Y-Axis Stops if desired. Loosen (turn knobs counterclockwise) the 2 Y-Axis Locks
(item
Å
) and position the raised portion of the stops to contact the back edge of the PCB. Lock in
position with the Y-Axis Locks.
3. Fine adjust the position of the component to be removed to the nozzle or the component being placed
to the PCB land pattern in the following manner.
a) Turn the X-Axis Lock knob (item
±
) fully clockwise to lock metal slide rods in position.
b) Adjust table side to side position using the X-Axis Fine Adjust Control (item
Ã
).
c) Adjust table front to back position using the Y-Axis Fine Adjust Control (item
Â
).
d) Adjust Theta Rotation as necessary (see step 2e).