Pace TF 500, Инструкция по установке и эксплуатации

Страница: 16 / 31

12
Installation
An interface cable must be installed when using the HS 200 Heat Wave system with the ThermoFlo. If an
Advanced Placement Platform has been purchased, an adapter plate must be installed on the bottom of the Heat
Wave heater unit to allow mounting onto the Fine Adjustment Table.
1. The Heat Wave Interface Cable (part number
1332-0187) connects the ThermoFlo Unit to the
Heat Wave power source to provide on/off
control of the pump assembly in the Heat Wave.
Connect the cable between the Heat Wave
connector on the rear panel of the ThermoFlo
Unit and the like connector on the rear panel of
the Heat Wave power source.
Heat Wave Interface
2. If you have purchased a Fine Adjustment Work Platform, install the enclosed Adapter Plate onto the
bottom of the Heat Wave Heater Unit using the 4 mounting screws supplied with the plate. Place the
Heat Wave Heater Unit on Fine Ajustment Table, inserting the 4 pins on the Adapter Plate into the 4
pin holes on the table. Refer to illustrations.
Operation
The Heat Wave Preheating System can be used at any time in conjunction with the ThermoFlo but the Heat Wave
motor pump is controlled by the ThermoFlo unit in the Program Mode only. The stored parameters of the Profile
in use will control activation of the motor pump. The temperature of the Heat Wave is not set or controlled by the
ThermoFlo. The temperature must always be set on the Heat Wave power source.