ORTAL Clear 130 LS, Инструкция по установке и эксплуатации

Страница: 35 / 67

35
Vent Clearances
The following clearances apply to the vent system regardless of vent manufacturer.
Vent Clearances
Sides: 1”
Applies to entire circumference
when venting is oriented vertically.
Clearance is to
any
material.
*Top: 3”
Applies to venting oriented
horizontally or at an angle.
Clearance is to any material. Bottom: 1”
*Exception: Wall thimble top clearance to any
material is 1”.
Minimum Vertical Rise (V minimum)
Series
40-170*,
Wild 44-61
3 feet
Required from the top of
the fireplace before any
offset can be used**
Series
200-250
6 feet
*Includes Island and Curve fireplaces.
**See “Offset Maximum Exception" below.
Offset Maximum
Up to 180˚ of offset (elbows ) can be used in the vent configuration. If the vent configuration exceeds this maximum, consider an Ortal
Power Vent System, which can allow for up to 540˚ of offset. See the Ortal Power Vent Manual for details.
Offset Maximum Exception
Two 45˚ offsets may be used directly on the fireplace with up to a 12'' straight section between them. The minimum vertical rise starts
above them. They do not count in the offset total.
NOTE: If the initial vertical vent rise off the top of the fireplace does not meet the V minimum, consider an Ortal Power
Vent System, which can allow for any initial vertical rise amount. See the Ortal Power Vent Manual for details.