PULSAR Minimal Stress
Installation and operating Manual
OPTIKON 2000
Cod. 111001EN
2012-02-16 Rev.J
8-22
(below). An asterisk will appear in ACT. PROG. to indicate that the program has
been modified. Press "SAVE" key <A> to permanently save the modification.
8.8 SHUTDOWN PROCEDURE
NOTE:
If the Pulsar surgical system is not used for an extended period, follow the procedure described
below.
1)
Press the “POWER” switch to turn off the console.
2)
Disconnect the power cable from the rear panel of the console. Grasp the plug,
not the cable.
3)
Disconnect the footswitch control from the rear panel of the console.
4)
Close the stopcock of the circuit for dosing via I.V. drip.
5)
Remove the irrigation and aspiration lines from the handpiece and from the
control panel.
6)
Remove the handpiece connectors from the control panel and place the
protective caps back on their tips.
7)
See the chapter “Cleaning, sterilization and maintenance”.
