Omron SYSMAC W398-E1-1, Руководство по эксплуатации

Страница: 118 / 127

104
NC Unit Error Logs Section 10-1
Multiple
axis start Multiple axis
start 8000 Two or more of the following com-
mands were executed simulta-
neously for the same axis:
START, INDEPENDENT START,
ORIGIN SEARCH, ORIGIN
RETURN, PRESENT POSITION
PRESET, JOG, TEACH,
RELEASE PROHIBIT/ERROR
RESET, ABSOLUTE MOVE-
MENT, RELATIVE MOVEMENT,
or INTERRUPT FEEDING
Correct the ladder pro-
gram so that just one
command is executed
for each axis at one
time and execute the
command again. The command will not
be executed.
If the last command
made before the error
was START, INDE-
PENDENT START,
ORIGIN SEARCH,
ORIGIN RETURN,
JOG, ABSOLUTE
MOVEMENT, RELA-
TIVE MOVEMENT, or
INTERRUPT FEED-
ING, the axis with the
error will be deceler-
ated to a stop.
When interpolation
operation is being
used, all interpolated
axes will be deceler-
ated to a stop.
If the error is gener-
ated during data trans-
fer (read or write) or
data saving, all axes
will be decelerated to
a stop.
Any operating axes
not specified above
will not be affected.
One of the following commands
was executed for a busy axis:
ORIGIN SEARCH, ORIGIN
RETURN, PRESENT POSITION
PRESET, JOG, TEACH,
RELEASE PROHIBIT/ERROR
RESET, ABSOLUTE MOVE-
MENT, RELATIVE MOVEMENT,
or INTERRUPT FEEDING
Correct the ladder pro-
gram so that a com-
mand is not executed
for a busy axis and
execute the command
again.
A data save operation was exe-
cuted while one of the following
commands was in progress:
START, INDEPENDENT START,
ORIGIN SEARCH, ORIGIN
RETURN, PRESENT POSITION
PRESET, JOG, TEACH,
RELEASE PROHIBIT/ERROR
RESET, ABSOLUTE MOVE-
MENT, RELATIVE MOVEMENT,
or INTERRUPT FEEDING
Correct the ladder pro-
gram so that the data
save operation is exe-
cuted while none of the
axes are busy. Execute
the data save opera-
tion again.
Two or more of the following com-
mands were executed:
DATA WRITE, DATA READ, or
DATA SAVE
Correct the ladder pro-
gram so that more than
one data transfer (read
or write) or data save
operation is not exe-
cuted at the same
time. Execute the data
transfer or data save
operation again.
A START or INDEPENDENT
START command was executed
for a different axis, but a busy axis
was specified in the axis designa-
tion. Correct the ladder pro-
gram so that busy axes
are not specified for
memory operation and
execute the command
again.
Group Name Code Cause Clearing method Operation after error