199
F3SJ-A
User’s Manual
Chapter
7
Acc
ess
ories
(
S
old Se
par
a
te
ly)
Appendix
E
Control unit
Spatter protection cover (2 cables per set, common for emitter/receiver)
Protect bar (1 set, common for emitter/receiver)
Protection bracket for protect bar (4)
Appearance
Model name
Output
Note
G9SX-AD322-T15
Solid-state output
(Instantaneous
output X 3, OFF-
delay output X 2)
- F39-JC
A cable with connector on one
end is required.
- F3SJ with PNP output can be connected.
- OFF-delay within 15 seconds can be set to
16 levels.
- Use as instantaneous output is possible by
setting OFF-delay output to 0 seconds.
- Can be configured for partial control and
total control.
- Relay unit can also be connected.
Appearance
Model name
Note
F39-HJ
In this table, the
in the model indicates the same 4-digit
number as the protective height (
in the model) of the
F3SJ.When a spatter-proof cover is attached, operating range of
F3SJ is reduced by about 10%.Spatter-proof cover with 1970 or
higher of
in the model is divided into 2 in combination to
use.
Appearance
Model name
Note
F39-PJ
-S
One protect bar is provided in a set (common for emitter/
receiver). If both of an emitter and a receiver need a
protect bar respectively, you must purchase 2 sets. For
side mounting of F3SJ with a width of 1001mm or wider,
you must purchase protection bracket (4) for protect bar
(F39-PJ-MS).
Appearance
Model name
Note
F39-PJ-MS
Intermediate mounting bracket for side mounting using a
protect bar. You must purchase 1 set for F3SJ with
protective height from 1001 to 2000mm, or 2 sets for
F3SJ with protective height of 2009 to 2495mm.
Courtesy
of
CMA/Flodyne/Hydradyne
▪
Motion
Control
▪
Hydraulic
▪
Pneumatic
▪
Electrical
▪
Mechanical
▪
(800)
426-5480
▪
www.cmafh.com
