Omron Sti F3SJ-A Series, Руководство пользователя

Страница: 112 / 230

92
Ch
apt
e
r
3
Set
ting Adjust
ed
to Appl
ication
F3SJ-A
User’s Manual
What can be done by the setting tool
„
Override Function
„ Overview
Configures override function.
The override function disables safety functions of the device. You must ensure safety using other
measures during this function is enabled.
All external indicators that indicate state of override function must be installed where workers can see
them from all the operating positions.
Install the switch that activates the override and that uses hold-to-run device, such as spring-return key
switch, in a location that provides a clear view of the entire hazardous zone and where it cannot be
activated from within the hazardous zone. Make sure that nobody is in the hazardous zone before
activating the override function.
Override time must be properly configured for its application by a sufficiently trained and qualified
person.
„ Example
•To extend override continuance time
„ Functional Description
• Override Function
The setting tool can disable override function. (Enabled for factory shipment)
Override Function p.52
• Override Time Limit
Override continuance time at the function’s activation can be changed. (60s for factory shipment)
„ Setting Change
Configure in a bulk in case of a series connection. (to be written into the primary sensor only)
If override function is enabled, we recommend either output mode of external indicator output 1, 2, or auxiliary output
1 should be configured as shown below.
- Override information
- Muting/override information
„
Setting Zone Adjacent Conditions
If any two functions of muting, fixed blanking, floating blanking, or warning zone functions are used at
the same time, the setting zones have limitations.
This section describes the limitations for following points:
1. Zone adjacent condition: If zones for multiple functions are configured adjacently
2. Zone overlap condition: If zones for multiple functions are configured as overlapped
Function Initial Setting Available Setup Item Setting Console PC Tool For F3SJ
Override Function Enabled Enable/disable – 3
Override Time Limit 60s 1s to 600s (by 1s)
3 3
Courtesy
of
CMA/Flodyne/Hydradyne
▪
Motion
Control
▪
Hydraulic
▪
Pneumatic
▪
Electrical
▪
Mechanical
▪
(800)
426-5480
▪
www.cmafh.com