Omron CX-MOTION-NCF - V1.9, Руководство по эксплуатации

Страница: 83 / 147

59
Uploading Data Section 7-4
If the connection cannot be established at this point, the following dialog
box will be displayed. Click the
OK Button and the axes registered in the
Position Control Unit will be displayed as Unknown Model.
6. If the connection was established at Step 4, the connection status can be
restored (released in this case) here. To release the connection, click the
OK Button. To leave the connection established, click the Cancel Button.
7. When the Upload from NC Unit Dialog Box is closed, the upload will be
completed.
Note Batch uploading will overwrite the parameters on the computer, which means
that the parameters being edited will also be erased.
When the MECHATROLINK communications cannot be started, only Unit
Parameters can be uploaded.
7-4-2 Uploading Unit Parameters
1,2,3... 1. Click the Upload Button in the Edit Unit Parameter Window.
2. Clicking the OK Button will start uploading Unit Parameters from the Posi-
tion Control Unit.
Clicking the
Cancel Button will cancel uploading.
3. When the Upload from NC Unit Dialog Box is closed, the upload will be
completed.