Omron CX-MOTION-NCF - V1.9, Руководство по эксплуатации

Страница: 79 / 147

55
Downloading Data Section 7-3
2. Click the OK Button.
If the communications between the Position Control Unit and Servo Drive
are established at this point, the following dialog box will be displayed to
confirm whether to release the connection or not.
3. Click the OK Button to release the connection and start downloading Unit
Parameters to the Position Control Unit.
Clicking the
Cancel Button will cancel downloading, however, the param-
eters that were downloaded before the cancellation should be downloaded
to the Position Control Unit.
4. If the checkbox for writing to flash memory was selected a few steps be-
fore, the following dialog box will be displayed to confirm that the Position
Control Unit will be restarted to enable the registered axis map after com-
pletion of the download.
5. Click the OK Button to restart the Position Control Unit.
6. If the connection was released in step 2, the connection status can be re-
stored (established in this case) here. To establish the connection, click the
OK Button. Otherwise, click the Cancel Button.
7. When the Download to NC Unit Dialog Box is closed, the download will be
completed.