Omron CX-MOTION-NCF - V1.9, Руководство по эксплуатации

Страница: 131 / 147

107
Error Codes Section 11-2
A.d1 --- --- --- --- 40D1 Motor-load devia-
tion over The deviation between the
fully-closed encoder and semi-
closed encoder has reached or
exceeded the command unit
set in Pn51A.
A.E0 --- --- --- --- No code
(See note
2.) No option The MECHATROLINK-II Appli-
cation Module is not installed.
--- A.E0
@
--- --- --- COM alarm An error occurred in the Servo
Drive.
--- --- A.E0 --- --- Internal synchro-
nization error 1 Communications link between
MECHATROLINK-II and Servo
Drive has been disconnected.
A.E1 --- --- --- --- No code
(See note
2.) Option timeout There is no response from the
MECHATROLINK-II Applica-
tion Module.
A.E2 --- --- --- --- No code
(See note
2.) Option WDC
error An error has occurred in the
MECHATROLINK-II Applica-
tion Module. (MECHA-
TROLINK-II Application
Module's watchdog timer
count)
--- A.E4 @ A.E4 --- --- 40E4 Transfer cycle
setting error The MECHATROLINK-II trans-
fer cycle setting is incorrect.
A.E5 A.E5
@
A.E5 --- --- 40E5 Synchronization
error MECHATROLINK-II synchroni-
zation error
A.E6 A.E6 @ A.E6 --- --- 40E6 Communications
error MECHATROLINK-II communi-
cations error
(Continuous communications
errors have occurred.)
A.E7 --- --- --- --- 40E7 Option detection
error The MECHATROLINK-II Appli-
cation Module has been
removed.
A.EA A.EA @ --- --- --- 40EA Servo Drive mal-
function The Servo Drive has malfunc-
tioned.
--- --- A.EA --- --- Internal synchro-
nization error 2 Communications link between
MECHATROLINK-II and Servo
Drive has been disconnected.
A.EB --- --- --- --- 40EB Servo Drive ini-
tial access error The Servo Drive initial pro-
cessing cannot be executed
from the MECHATROLINK-II
Application Module.
A.EC --- --- --- --- 40EC Servo Drive error An error has occurred in the
Servo Drive.
(Servo Drive's watchdog timer
count)
A.ED A.ED @ --- --- --- 40ED Command execu-
tion incomplete MECHATROLINK communica-
tions command aborted during
execution.
--- --- A.ED --- --- Internal com-
mand error A command error has occurred
inside the Servo Drive
A.F1 A.F1 @ --- --- --- 40F1 Missing phase
detected Main circuit power supply
phase is missing, or the wire is
burnt out.
Servo Drive display Position
Control
Unit error
code
Error detection
function
Detected error or cause of
error
W
Series
W-series
(Built-in
Commu-
nica-
tions
Type)
SMART-
STEP Jun-
ior (Built-
in commu-
nications
Type)
G-Series
(Built-in
commu-
nica-
tions
Type)
G5-Series
(Built-in
commu-
nications
Type)