Omron CX-MOTION-NCF - V1.9, Руководство по эксплуатации

Страница: 134 / 147

110
Error Codes Section 11-2
Note (3) If a Parameter Setting Warning or MECHATROLINK-II Command Warn-
ing occurs in the Servo Drive, a data setting error (axis error code: 3099)
will occur at the Position Control Unit, and the active axis in which the er-
ror occurred will decelerate to a stop.
(4) If a MECHATROLINK-II communications error occurs once independent-
ly, a communications warning occurs, and the Position Control Unit will
perform a communications retry. If the communications warning occurs
continually, a communications error will occur.
--- --- --- --- A5 40A5 Encoder over-
heating warning The encoder detected a over-
heat warning.
--- --- --- --- A6 40A6 Vibration detec-
tion warning Vibration was detected.
--- --- --- --- A7 40A7 Limit detection
warning The remaining service life of a
capacitor or a fan is shorter
than the specified value.
--- --- --- --- A8 40A8 External scale
error warning The external scale detected a
warning.
--- --- --- --- A9 40A9 External scale
communications
warning The number of external scale
communications errors
exceeded the specified value.
Servo Drive display Position
Control
Unit error
code
Warning
detection
function
Warning details
W
Series
W-series
(Built-in
Communi-
cations
Type)
SMART-
STEP
Junior
(Built-in
communi-
cations
Type)
G-Series
(Built-in
communi-
cations
Type)
G5-Series
(Built-in
communi-
cations
Type)