Omron BU100RS, Инструкция по эксплуатации

Страница: 46 / 102

3 Check and start operation
3-2 Checking the operation
BU100RS
45
3
4.
Under this condition, check the unit's LED display and beep sound.
Are they in the same status as shown below?
Status indicator
Beep None
Power supply output receptacles Outputs power (connected devices are powered)
If the same as the one shown above:
The operation is normal. Proceed to procedure 5.
If not the same as the one shown above:
The operation is abnormal. "3-4-4 Displays and beeps when there is an equipment failure"
of "3-4 Interpreting beeps and displays" must apply.
Take necessary measures and then proceed to 5.
5.
Disconnect the unit’s AC input from the commercial power. The unit enters Battery
Mode.
6.
In Battery Mode, check the unit's LED display and beep sound.
Does the status indicator appear as one of those shown below? ( indicates blinking)
Status Indicator Beep Output Description
Intermittent
4-second intervals
ON Backup is operating due to power failure or AC input
error. Output will stop if Battery Mode continues.
Intermittent
1-second intervals
ON Backup is operating due to power failure or AC input
error. Battery level is low, so output will stop soon.
None OFF Battery is dead, so output stopped.
If not the same as one of those shown above:
... Operation is abnormal. Check the status of lamps and beep, and then press the
“Power” switch to turn OFF the power.
・ If the display is one of those shown in “3-4 Interpreting beeps and displays”, take
the necessary measures and then go back to procedure 1.
・ If no Battery Mode is performed and the UPS and the devices connected to the
UPS stop, this may be attributed to an insufficient battery charge.
After connecting the AC input to the commercial power and charging the battery
for at least 8 hours, go back to step 5.
・ If the problem persists after checking the 2 points above, contact us.